ICC9 Repair Tips

Search: ICC9

Results 116

Make	Model Ch.	Symptom	Problem Solution
Ferguson	ICC9	Ew distortion	Check / replace CL42 4.7uF, 160v, don`t forget to use 105 Celsius type replacement
Nordmende	SC63SF ICC9	OSD appears as one big horizontal line with wrong colours and noise looks like no hor. sync. Teletext is ok	Replace proc. IR01 ST9293 which contains the OSD functions. expensive IC
Telefunken	Palcolor S540C ICC9	Geen blauwe kleur	SMD transistor TV81 Bc858 defect.
Telefunken	PALCOLOR F531 ICC9	Stand-by led flash but set does not start	Replace: TL19 BUH517, DL21 and DL22, CL21 and CL22
Thomson	ICC9 37MG73J	Pic break up with folded horiz lines at bottom half	RF11 safety res 1R5 o/c pt no 15022560
Thomson	ICC9 37M973J	service mode entering	Switch on holding in Blue Txt button then press blue button again
Thomson	ICC9 37M973J	E-W bowing	IV01 STV2160 replaced & uprate CV46 from 10nF to 22nF sm; RL45 3R3 o/c, LL08 pt no 10092690, CL42 4µ7 160v
Thomson	ICC9	Trips on & off aft 1 min	OK when you s/c TR96 sm st/by tr - TV92 sm was the cause even tho it check ok out of cct
Goodmans	GD2880A ICC9	TV works ok but LED red not Green	TR28 BC858B sm s/c
Goodmans	GD2880A ICC9	St/by only	TP66 BC858B sm
Goodmans	GD2880A ICC9	Int dead	Volts around TR85 BC848B & TR87 BC858B incorrect - Trs faulty
Goodmans	GD2880A ICC9	Crackling on NICAM	Possible changing TDA8732 & 13.104Mhz filter 1N01 pt no 1025398000 together will cure
Goodmans	GD2880A ICC9	Blank raster - ok via scart	TX16 BC858B in scart sect faulty
Goodmans	2880 (ICC9)	WAVY PICTURE WITH BENT VERTICALS	REPLACE IP03
Goodmans	2880 (ICC9)	STUCK IN STANDBY	REPLACE TP66
Goodmans	2880 (ICC9)	NO BLUE	CHECK TV81
Goodmans	2880 (ICC9)	INT FRAME CRAMPING	REPLACE DF31
Goodmans	2880 (ICC9)	2 INCH BAR OF SNOW AROUND BLANK SCREEN	REPLACE TR42
Goodmans	2808 ICC9	White streaks over screen	TC03 BC858B sm lum buffer
Goodmans	2808 ICC9	No tuning - ok thro' SCART	TH01 BC847B sm